Fitment
Universal for Turbo Manifold with T25 Flange(T28 Flange can be converted to T25 Flange, Adrapter is needed).
Perfect for all 1.5L-2.0L engine, for all 4 cylinder engine 

Specification
Exhaust Inlet Flange: Standard T25 Flange 
Exhaust Outlet  Flange: 5-Bolt 
Turbine Side: 
Turbine Trim: 76.3 
Turbine A/R: 0.64 
Turbine Inducer Diameter: 53.8mm 
Turbine Exducer Diameter: 47mm 
Compressor Side: 
Compressor Trim: 48 
Compressor A/R: 0.60 
Compressor Inducer Diameter: 49.2mm 
Compressor Exducer Diameter: 71 mm 

Bearing Type: Wet Float 
Cooling Type: Water + Oil Cooled 
Thrust Bearing: 270 Degrees 
Wastegate: with Wastegate 
Oil Restrictor: Yes 
Oil Restrictor Size: inside diameter 2mm 
Oil Feed Size: 12mm 
Oil Inlet: M121.25 
Oil Drain Size: 14mm 
Oil Outlet: M14 & 2M81.25 
Oil Drain Thread Pitch: 40mm 
Water Thread Size: M141.5 
Horse Power: Boost Horse Power up to 350BHP 
Turbo Type: Individual 
Universal Fitment: Yes 
Finish: Matte 
Condition: 100% Brand New 
Accessories: You will get exactly as shown as picture above 

Notice 
Replace, repair or reconnect air cleaner element per manufacturer's manual to avoid compressor wheel damage.
Make sure the oil drain line is lower than the turbo itself.
Gasoline car must install a water cooling device to avoid overheating.
Ensure exhaust outlet are well sealed by welding
The degree of modification of the universal turbo depends on your individual vehicle.Professional installation is highly recommended.
This Turbo is not vehicle specific. Please check the specifications and verify compatibility prior to placing your order.
Before installing the new turbocharger, the cause that led to the failure of the turbo must be analyzed and eliminated (e.g. insufficient oil supply, foreign bodies in the intake area, crankcase ventilation without function, etc.)!