Fitment
For 2WD Only 
For Volkswagen Golf MKII 1985-1992 (19E)
For Volkswagen Golf MkIII 1991-2000  (1H) 
For Volkswagen Jetta II 1984-1992 (1G)
For Volkswagen Vento/Jetta III 1993-1998 (1H) 
For Volswagen Carrado 1988-1995 (53I) 
Notice:No Top Mount Included,Modification Required If You Use OE Top Mount 

Specification 
Height adjustable: Yes, lowering 0-25mm depending on the vehicle models 
Damping : Not adjustable 
Top mounts: OE top mounts required
Camber adjustable: Not available 
Spring rate Front: 7 kg/mm (392 lbs/in) 
Front spring inner diameter: 62 mm 
Spring length Front: 200 mm 
Helper spring rate Front: 1 kg/mm (56 lbs/in) 
Helper spring length Front: 102 mm 
Spring Preload advised: 7-10 mm 
Shock type: Twin tube 

Package included 
2x Front coil-overs 
2x C spanners 

Feature 
0-25mm(depends on vehicle models) lower height adjustable
Dust boot, solid rubber bump stops
Weight Saving Aluminum Components And heavy duty Steel Lower Mount Brackets
Simple install, Easy to adjust.
Use the vehicle's original upper mounts (not included in our product kit).

Note
All modifications must be installed by licensed mechanics and in compliance with your local modification regulations.
Please ensure all components are tightened with correct torque specifications (which can be found in the vehicle service manual)before and after installation. Any loose nuts, bolts, or locks will cause noise. Do check and tighten before serious problems happen.
Impact wrench is prohibited during the installation, it will loosen or damage the product.
Examine the clearance between tires and suspension. ( The minimum clearance should be 4mm, otherwise, you need to add wheel spacers. Caution: It is not sufficient with torsion beam trailing arm axles)
We suggest regular maintenance for the coil-over, spray with some WD40 every 3-4 months will keep it smooth and clean, which helps to extend the lifetime.